Hardware

Warp3D Requires:

• Either an 68040/060 with FPU or a PowerPC.
• Approximately 2 Megabytes of memory
• A compatible graphics system (see below)
• A graphics card. Currently, there's no AGA support, but this is being considered.

The following graphics subsystems are supported

• CyberGraphX V2/V3
• CyberGraphX V4 (in preparation)
• Picasso96
• RTGMaster (in preparation)

Furthermore, there's support for the following chips:

S3 ViRGE

This chip is already quite old, and the predecessor of the Savage 3D. Used on the CyberVision64/3D

Permedia 2 (in the works)

This modern chip from 3DLabs is currently in use on CyberVisionPPC and BlizzardVisionPPC boards.